Elegoo pla temp help : r/FixMyPrint

Silk rainbow Pla no layer adhesion : r/FixMyPrint

ELEGOO PLA Filament 1.75mm Beige 1KG, 3D Printer Filament Dimensional Accuracy +/- 0.02mm, 1kg Cardboard Spool(2.2lbs) 3D Printing Filament Fits for Most FDM 3D Printers : Industrial & Scientific

Layers problem Elegoo Neptune 4 Pro : r/FixMyPrint

Elegoo Neptune 3 Pro upturned corners (heat rising?) : r/FixMyPrint

Elegoo Neptune 3 max. No matter what I do it always peels up or one corner warps. : r/FixMyPrint

My printer refuses to print in white PLA filament : r/FixMyPrint

what to fix? silk pla, temp tower elegoo neptune 3 pro : r/ElegooNeptune3

S3 Temperature Tower - Elegoo PLA+ White : r/VoxelabAquila

Trying to figure out correct settings for inland silk pla, lots of little globs and stringing : r/FixMyPrint

Atrocious first layer in PETG. Same print+setting in PLA was perfect. Filament are in active dryer box (50c/48hrs so far) . Could it be just bad filament (Sunlu PETG)? First layer temp 250, any temp below would not stick for this particular filament. : r/FixMyPrint

Poor overhangs & curling (Prusa MK3S+, Hatchbox PLA) : r/FixMyPrint

Ender 3, PLA, temp 215. Not sure what to even call this problemthe Two Face effect? : r/FixMyPrint

What's going on in the bottom left corner? Stringing and these weird squiggly thorn things. Steps dialed in. Ender 3 S1 elegoo pla 215-210 bed 60-50 only spot like this on the

Help, please : r/FixMyPrint