Creality BL Touch Kit - Ender 3 (8 bit mainboard - no bootloader)

Wide Application: Suitable for Ender-3 / Ender-3s / Ender-3 Pro / Ender 5 / Ender 5 Pro/ CR-10 / CR-10S / CR 10S4 / CR 10S5 / CR-20 / CR-20 Pro. NOT SUITABLE FOR Ender 3V2, CR-10V2, CR 10S Pro Use the ISP cable or SD card to flash the firmware for V1 mainboard(1284P). Use USB cable to flash for V2 Mainboard(2560P). The
Wide Application: Suitable for Ender-3 / Ender-3s / Ender-3 Pro / Ender 5 / Ender 5 Pro/ CR-10 / CR-10S / CR 10S4 / CR 10S5 / CR-20 / CR-20 Pro. NOT SUITABLE FOR Ender 3V2, CR-10V2, CR 10S Pro Use the ISP cable or SD card to flash the firmware for V1 mainboard(1284P). Use USB cable to flash for V2 Mainboard(2560P). There are two different versions instruction for V1 and V2 mainboard. Easy to Use: BLTouch’s Standard Deviation in repeatability is 0.005mm. Genuine Creality Kit: Includes 1 set of auto bed Leveling Kit and replacement probe. Simple, smart and easy to install. 8-bit mainboard

Creality Ender 3 V2 Upgrades V4.2.7 Silent Board, 32 Bit Silent Mainboard with TMC2225 Drivers Compatible for Creality Ender 3, Ender 3 Pro, Ender 5, Ender 5 Pro 3D Printer : Industrial & Scientific

Creality V4.2.2, V4.2.3, V4.2.7 & V4.3.1 board BLTouch/CRTouch Wiring Options - TH3D Studio Help Center

Wide Application: Suitable for Ender-3 / Ender-3s / Ender-3 Pro / Ender 5 / Ender 5 Pro/ CR-10 / CR-10S / CR 10S4 / CR 10S5 / CR-20 / CR-20 Pro., NOT

Creality BL Touch Kit - Ender 3 (8 bit mainboard - no bootloader)

Motherboard Creality 4.2.7, 32-bit - Majkl3D

Review - Creality Ender 3 v4.2.7 Motherboard - 3D PRINTING UK

i think my ender three screen ribbon cable is glued on. is this glue? Trying to install BL touch and this rabbit hole just. keeps. going. : r/ ender3

Creality 3d New Upgrade Silent 1.1.4 Mainboard Installation

What am I missing here? Just bought a Creality CR Touch ABL kit and was about to plug in the wire to the mainboard, when I realized that I didn't see any

Firmware Update for 32-bit Controller Board on Ender-3, PRO, or V2

Looking for an Auto Bed Leveler for Ender 3 v.1.1.4. Can bl touch work with this board? Can I update the firmware on this board for an ABL? : r/ender3