Free STL file Shelly H&T Case (external Power Supply) 🔧・3D printable model to download・Cults

This is a simple case for the Shelly H&T sensor. One Base is with mounting points for a step down module one is without them. Both come with a 4mm hole for a USB Cable. The Shelly H&T twists into the lid like in the original case As the Shelly H&T only is rated for 3V you should use some type of voltage regulator! additionaly needed:

• 4 2.9mm x 9mm screws for the lid
• 2 2.9mm x 6mm screws for the step down module if used
• USB Cable
• Voltage regulator / Step down Module

Shelly best STL files for 3D printing・55 models to download・Cults

shelly ht 3D Models to Print - yeggi

triacs regulator 3D Models to Print - yeggi - page 57

9mm case by 3D Models to Print - yeggi - page 4

Free STL file Shelly H&T Case (external Power Supply) 🔧・3D

for on cable wiring (similar to shelly button)., The other relays in the PLUS line are supposed to have the same external dimensions, so

Shelly 1PM PLUS case

shelly plus 3D Models to Print - yeggi

Shelly best STL files for 3D printing・55 models to download・Cults

Shelly best STL files for 3D printing・55 models to download・Cults