PLA Filament, 3D4Makers

€ 8.50 · 4.8 (325) · In Magazzino

Di uno scrittore di uomini misteriosi

PLA Filament PLA Filament (Polylactic Acid) is a biodegradable polymer coming from renewable organic resources (corn starch or sugarcane). PLA Filament is recyclable but can also be biological decomposed in composting plants. Due to a low shrinkage factor PLA will not deform after cooling, this makes the material ideal for 3D printing on FFF / FDM machines. Polylactic acid is a polyester that is built from several lactic acid units. It is colourless and transparent. PLA has a density of about 1.24 g/cc. The glass temperature is typically around 50 °C and it as a melting temperature between 80 and 150 °C. The decomposing temperature is roughly 250 °C. Polymers made of lactic acid are flammable. Great printability Biodegradable Food contact approved Printer settings Description Value Printer nozzle temperature 180 - 220°C Heated bed temperature 20 - 60°C Bed Adhesion Magigoo
PLA Filament PLA Filament (Polylactic Acid) is a biodegradable polymer coming from renewable organic resources (corn starch or sugarcane). PLA Filament is recyclable but can also be biological decomposed in composting plants. Due to a low shrinkage factor PLA will not deform after cooling, this makes the material ideal for 3D printing on FFF / FDM machines. Polylactic acid is a polyester that is built from several lactic acid units. It is colourless and transparent. PLA has a density of about 1.24 g/cc. The glass temperature is typically around 50 °C and it as a melting temperature between 80 and 150 °C. The decomposing temperature is roughly 250 °C. Polymers made of lactic acid are flammable. Great printability Biodegradable Food contact approved Printer settings Description Value Printer nozzle temperature 180 - 220°C Heated bed temperature 20 - 60°C Bed Adhesion Magigoo Original on glass or a PEI Sheet Physical properties Description Value Test method Density 1,24 g/cc ISO 1183 Tensile strength at yield 66 MPa ISO 527 Tensile (E) modulus 3027 MPa ISO 527 Impact strength - Charpy method 23˚C 3,4 kJ/m² ISO 179 Moisture absorption 1968 ppm ISO 62 Glass transition temp 57°C ISO 11357 Measurements & Tolerance Size Diameter tolerance Roundness 1,75 mm Filament +/- 0,05mm 95% 2,85 mm Filament +/- 0,10mm 95% Additional info To get the best results while printing we advise you to keep the 3D printer in a room where there is hardly any draft and/or temperature fluctuations. Keep the 3D printer out of the sun. When the 3D printer is not being used it is important to keep the 3D4MAKERS PLA Filament in a bag and stored in a cool (15-25˚C) and dry room away from UV light until it is used again.