Relay 12V with Optocupler, how to? - General Electronics - Arduino

hi guys, I have this relay: im trying to connect it this way: (althoug the next image is a 5V relay im using the 12V one, it waas easy to find the image of the 5V but my relay is the 12V one) If I connect the DC+ and DC- to the arduino directly, the green light of pwer from the relay turn on, and with the blink program the red light of the relay is turning off and on and the blink in the arduino is also working(i added the blink in both arduino and relay ti see what happens), so the sign

4n35 Optocoupler as Switch - #16 by Tinkering - General Electronics - Arduino Forum

Is my relay broke? - General Electronics - Arduino Forum

12V 1 Channel Relay Module with Optocoupler for Arduino – Aideepen

16 Channel Relay Shield Module DC 5V 12V 24V with Optocoupler LM2576 Microcontrollers Interface Power Relay

12V 1 Channel Module with Optocoupler Isolation High and Low Level Tri – Aideepen

The Basics of Optocoupler Relay

Opto isolated dual relay module (Arduino)

2 Channel Relay Not Working No Matter What I Do! - General Electronics - Arduino Forum

Input on Relay: The control of loop of earth wire - General Electronics - Arduino Forum

8 Channel 12V Relay Board with Optocoupler at

How do I connect this solenoid relay board? - General Electronics - Arduino Forum

Relay 12V with Optocupler, how to? - General Electronics - Arduino Forum

HiLetgo 12V 1 Channel Relay Module with Optocoupler Isolation Support High or Low Level Trigger : Industrial & Scientific

Relay 12V with Optocupler, how to? - General Electronics - Arduino Forum

How to use 12V Relay module with Arduino to control High Voltage Devices