Average-Value DC-DC Converter Control - MATLAB & Simulink

This example shows how to control the output voltage of a buck-boost converter.
Control the output voltage of a buck-boost converter. To adjust the duty cycle, the Control subsystem uses a PI-based control algorithm. An average-value DC-DC converter model is used to speed up the simulation. The input voltage and the system load are held constant throughout the simulation. The total simulation time (t) is 0.25 s. At t = 0.15 s, the voltage reference changes and the system switches from buck mode to boost mode.

Average-value DC-DC converter - MATLAB

Modelling and control of a non-isolated half-bridge bidirectional DC-DC converter with an energy management topology applicable with EV/HEV - ScienceDirect

Linearize DC-DC Converter Model - MATLAB & Simulink

Buck-boost DC/DC converter - imperix

Linearize DC-DC Converter Model - MATLAB & Simulink

Average Model of a 100-kW Grid-Connected PV Array - MATLAB & Simulink

Applied Sciences, Free Full-Text

Continuous input current buck DC/DC converter for small-size wind energy systems featuring current sensorless MPPT control

Project 1 - Loss calculation for a DC/DC converter-MATLAB

Can anyone please share a Simulink model of a Bidirectional DC-DC converter?

MATLAB/Simulink-Based Grid Power Inverter for Renewable Energy Sources Integration

Two-Phase DC-DC Converter Current Control - MATLAB & Simulink

Review on non-isolated DC-DC converters and their control techniques for renewable energy applications - ScienceDirect

Power Losses Investigation How to Develop DC-DC Converter Control in Simulink, Part 3 - MATLAB & Simulink

Average-value chopper - MATLAB