LED strip dim and MOSFET very hot when powered through Arduino - Project Guidance - Arduino Forum
€ 24.50 · 4.5 (796) · In Magazzino
Di uno scrittore di uomini misteriosi
Hi, I have been using the following setup to power and control 12V led strip through my Arduino Uno R3: Everything was fine when I used a short strip, but now I wanted to try and control a bit longer (5m = 14.4W/m) 2 pin led strip. When I connect everything up and power on (12V, 5A source), the led strip is noticeably dimmer than it would be powered straight from the source. It's got red and blue lights mixed and there is no clear pattern, but a few leds in a row would be brighter, then like
MOSFET Switch behaves strange - Project Guidance - Arduino Forum
High power leds and led strips - General Electronics - Arduino Forum
LED strip dim and MOSFET very hot when powered through Arduino - Project Guidance - Arduino Forum
Using MOSFETs with RGBW striplights - LEDs and Multiplexing - Arduino Forum
Non-Addressable RGB LED Strip Hookup Guide - SparkFun Learn
RGB LED strip MySensors Forum
LED Strip / MOSFET / Arduino - best way to do - LEDs and Multiplexing - Arduino Forum
Yet Another LED Strip with Current Draw PWM Module and MOSFET Post - LEDs and Multiplexing - Arduino Forum
Arduino by Gunther Star - Issuu
Issues with controlling led light strip with MOSFET - General Electronics - Arduino Forum
arduino - Very hot mosfet when powering an led strip - Electrical Engineering Stack Exchange
How many 3mm LEDs can I power using an Arduino Micro? - Quora
arduino - Very hot mosfet when powering an led strip - Electrical Engineering Stack Exchange
using PWM to dim LED NEON STRIP, Page 5