PWM driving of high-power LED with an arduino - LEDs and
€ 15.99 · 4.9 (341) · In Magazzino
Di uno scrittore di uomini misteriosi
I need to drive 2 red and 2 blue high-power LEDs for an application (LED indicated below). First of all, I connected the LEDs directly to the 12V power supply and measured the currents they draw. As you can see, the red one draws about 1.4A. As you can see, the blue one draws about 0.5A. My question is that I want to use MOSFET to drive these LEDs with PWM, I have shared two circuits below which should I use?Why? Circuit-1 Circuit-2
Arduino LED - Complete Tutorial - The Robotics Back-End
Using LED Drivers with Dimming Control by Arduino
MeanWell HLG PWM controll - Project Guidance - Arduino Forum
LED PWM Help - Project Guidance - Arduino Forum
PWM driving of high-power LED with an arduino - LEDs and Multiplexing - Arduino Forum
High Power LED correctly with LM317 + IRF520N for Arduino Control? - General Electronics - Arduino Forum
PWM input with 5V/5A-8.5A - Project Guidance - Arduino Forum
For all of you out there who want to control 12 channels of PWM, we salute you! We also would like you to check out this breakout board for the
Adafruit 12-Channel 16-bit PWM LED Driver - SPI Interface
How to Control LEDs on the Arduino - Circuit Basics
Interfacing TLC5947 PWM Module with Arduino (12-Bit LED Drivers)
High Power LED correctly with LM317 + IRF520N for Arduino Control? - General Electronics - Arduino Forum
Not able to generate different voltages from Arduino PWM & MOSFET - General Electronics - Arduino Forum
LED Fading WIth a MOSFET and a Voltage Converter - LEDs and Multiplexing - Arduino Forum