LED and resistor in series from +5V to digital in - General Electronics - Arduino Forum

Possibly a daft question and I've very likely missed something somewhere but any search just brings up variations on the "blink" sketch. I'm wiring up a toggle switch across a digital input and was hoping to put in (for purely aesthetic purposes) an LED. TO save writing code is it alright to to put the resistor and LED off the com pin of the toggle switch to the digital pin so that when the switch has +5V across it the LED comes on?

Arduino - Controlling a WS2812 LED strand with NeoPixel or FastLED

RGB LED resistor question - LEDs and Multiplexing - Arduino Forum

Revisiting Resistors, All About LEDs

Arduino DigitalRead Generating Strange Results - Arduino - Core Electronics Forum

Relying on ATMEGA328 protection diodes. Electronics Forum (Circuits, Projects and Microcontrollers)

Op Amp Peak Detector - General Electronics Discussion - CircuitLab

Ohm's Law & LEDs - General Electronics - Arduino Forum

LED Intensity Control Using LDR : 5 Steps - Instructables

Flicker Leds with Digital Pin - Project Guidance - Arduino Forum

Start Light Gantry with Arduino Uno Analog pins (5 Red & 1 Green dual rows)

Why You Need an Analog Front End and How to Set It Up

Do I need resistors with same voltage power supply? - General Electronics - Arduino Forum

RX/TX voltage and LEDS

Arduino to Transistor and LEDs controlled by PIR sesnsor Electronics Forum (Circuits, Projects and Microcontrollers)