Ventilation: Shelly 2.5 with 3-level switch - ESPHome - Home

Hi, I’ve created a yaml config file for the following config: Venitlation unit (in my case a Storkair WHR 930), controlled via a Perilex Plug Old-fashioned 3-level switch to control the ventilation unit Shelly 2.5 to controll/influence the 3-level switch These ventilation units are controlled relatively simple: -when L1 is live/hot, the ventilation unit goes to medium -when L2 is live/hot, the ventilation unit goed to high -when L1 and L2 are not live, the ventilation unit goes to low -i

Shelly 2.5 gets stuck in a overheat state until Restart - ESPHome - Home Assistant Community

Wire Shelly 2.5 on a 3 stand rotary switch. Can I make channels work mutual exclusive ? - Shelly 2.5 - Offizielles technisches Shelly Support Forum (DACH)

Shelly 2.5

Shelly 2.5 getting hot to touch (63°C external case) - should I be worried? - Hardware - Home Assistant Community

Shelly 2.5: Flash ESPHome Over The Air!

Shelly Plus 2PM

Windows on Home Assistant – Flameeyes's Weblog

Shelly 2.5: Flash ESPHome Over The Air!

Which smart switch is needed? - #24 by stevemann - Hardware - Home Assistant Community

Shelly with ESPHome: OTA Rollback to Shelly? - ESPHome - Home Assistant Community

Shelly Story: From Stock Switch to Custom Smart Water heater Bluetooth control using ESPHome

Shelly 2.5: Flash ESPHome Over The Air!

Wire Shelly 2.5 on a 3 stand rotary switch. Can I make channels work mutual exclusive ? - Shelly 2.5 - Offizielles technisches Shelly Support Forum (DACH)